Documentation >
MAC-PAC Reference Library >
Manufacturing >
Master Scheduling >
Key Concepts and Procedures >
Potency >
Displaying Quantities in Potent or Standard Units
Displaying Quantities in Potent or Standard Units
Several modules display the planning balances, total balances, or on-hand quantities in terms of potent units or standard (stockkeeping) units on both screens and reports. This information is very important to planners when an exact quantity or percentage of a component is needed to create an end item. Several screens, in fact, allow you to display the quantities in either potent units or standard units by pressing F19. Refer to the following screen sample.
WILLIAMS CO 001 JOB CONTROL 3/05/93
DSP01 WHS BEL INVENTORY STOCK STATUS DETAIL
HY-PEROXIDE HYDROGEN PEROXIDE Unit Of Measure GA Prod Type MRP
Part Type MFG
On Hand Qty - Mfg 1000.000
Other Avail - Mfg .000
Available Qty - Dist .000
Last B Lot Number/
Stk Loc Tran Balance T Total Job/Group No Lot FiFo Dte
ALOCAT1 03/05/93 250.000 H 250.000 LOT33
03/05/93
ALOCAT2 03/05/93 250.000 H 250.000 LOT33
03/05/93
AMB 001 03/05/93 250.000 H 250.000 LOT33
03/05/93
AMB 002 03/05/93 250.000 H 250.000 LOT33
03/05/93
F2=Command F3=Exit F19=Potent Units
|
Inventory Stock Status by Job (JC840S02).
This screen displays the inventory balance by stock location for lot-controlled,
job-controlled, and potency-controlled parts. In this example, the quantities in
the Balance field are displayed in standard units.