Documentation >
MAC-PAC Reference and Help >
Reference File Categories >
CONTAINER PICKING CODES
Function Select
RFC08S01 - Function Select
WILLIAMS COMMON FEATURES 2/08/92
DSP01 REFERENCE FILE CATEGORY C08 FUNCTION SELECT
Category Name CONTAINER PICKING CODES
BLANK KEY
Category Key
Request Code 4
1 - Add
2 - Change
3 - Delete
4 - Inquire
F2=Command F3=Exit F7=End Category F8=Display List
F9=Inquiry
The Container Picking Codes category contains all of the valid container picking codes in the system.
There are two system-defined codes:
1 - Top
2 - Front
The system expects exactly these values. Unpredictable results will occur if you attempt to use any other values for the container picking codes without modifying the software appropriately.
This category is required if Design Engineering is installed.
This category has a blank key to allow only one record.
Detail
RFC08S02 - Detail
WILLIAMS COMMON FEATURES 2/08/92
DSP01 REFERENCE FILE CATEGORY C08 INQUIRE
Category Name CONTAINER PICKING CODES
BLANK KEY
Category Key
PICK FROM CODES: PICK FROM DECODES: TOP FRONT
Data 12 TOP FRONT
XX XXXXX XXXXX
Data
Data
F2=Command F3=Exit F9=Inquiry F10=Function Select
CONTAINER PICKING CODE
Required. Used to define the two container picking codes used in the system. These values must be 1 and 2.
CONTAINER PICKING DECODE
Required. Used to define the decode of the Top container picking code.
CONTAINER PICKING DECODE
Required. Used to define the decode of the Front container picking code.