Documentation >
MAC-PAC Reference and Help >
Reference File Categories >
CONBON CONTROL CODES
Function Select
RFC03S01 - Function Select
WILLIAMS COMMON FEATURES 2/08/92
DSP01 REFERENCE FILE CATEGORY C03 FUNCTION SELECT
Category Name CONBON CONTROL CODES
BLANK KEY
Category Key
Request Code 4
1 - Add
2 - Change
3 - Delete
4 - Inquire
F2=Command F3=Exit F7=End Category F8=Display List
F9=Inquiry
The CONBON Control Codes category contains all of the valid CONBON control codes in the system.
There are three system-defined control codes:
0 - No cards
1 - Single card system
2 - Dual card system The system expects these exact values. Unpredictable results will occur if you attempt to use any other values without modifying the software accordingly. This category is required if Design Engineering is installed.
This category has a blank key to allow only one record.
Detail
RFC03S02 - Detail
WILLIAMS COMMON FEATURES 2/08/92
DSP01 REFERENCE FILE CATEGORY C03 INQUIRE
Category Name CONBON CONTROL CODES
BLANK KEY
Category Key
CONBON CONTROL CODES:
Data 012
XXX
CONBON CONTROL DECODES: NONE SINGLE CONBON
Data NONE SINGLE DUAL
XXXXXX XXXXXX XXXXXX
Data
F2=Command F3=Exit F9=Inquiry F10=Function Select
CONBON CONTROL CODE
Required. Used to define the three CONBON control codes used in the system. These codes must be 0, 1, and 2.
CONBON CONTROL DECODE
Required. Used to define the decode for the None control code.
CONBON CONTROL DECODE
Required. Used to define the decode of the Single control code.
CONBON CONTROL DECODE
Required. Used to define the decode of the Dual control code.