Defining a Part's Standard Potency

The standard potency, which refers to a part's "usual" potency, is defined in the Part Master conversation. Enter the standard potency for a part on the Change Control screen (DE100S04). If you do not enter a standard potency, the field defaults to 100 percent.

In the example below, hydrogen peroxide has been defined as being lot controlled and potency controlled, and its standard, or usual, potency is 3%.

WILLIAMS   PLT BEL            DESIGN ENGINEERING                       3/05/93

 DSP01                    PART MASTER FILE MAINTENANCE          CHANGE(CONTROL)

                                                                               

                                                                               

  Part Number           HY-PEROXIDE         HYDROGEN PEROXIDE                  

                                                                               

  Commodity Code                            Issue Code            R            

                                                                                

  Customs Commodity Cde                     Tax Commodity Code                 

                                                                               

  Primary Location      NOPRLOC             SIR Location          NOSRLOC      

                                                                               

  Preferred Vendor                          Safety Stock Quantity     1000.000 

                                                                                

  Setup Cost              .0                Yield Factor            .00        

                                                                               

  Lot Control Option    Y                Job Control Option    N            

                                                                               

  Potency Control Opt   Y                Standard Potency        3.00       

                                                                               

                                                                               

 F2=Command          F3=Exit             F4=Prompt           F9=Inquiry        

 F10=Function Select F11=Part Comments   F15=Rekey Data

The Part Master Maintenance Change Control Screen (DE100S04)

This screen is used to define whether a part is potency controlled and its standard potency.

Menu

Defining a Part's Standard Potency