MAC-PAC Homecontact ussupport login 
Documentation > MAC-PAC Reference Library > Manufacturing > Inventory Control > Key Concepts and Procedures > Lot Control > Defining the Lot Control Option for the System

Defining the Lot Control Option for the System

 

A single lot control option is set for the entire system on the Application System Control File, which is found on the Material Planning Menu.  This option can be either Yes or No.  You should set this flag to Yes if you wish to use lot control anywhere in the system.  If you set this option to No, lot control information will not appear on screens and reports throughout the system. 

Note:    If you decide to make your environment non-lot-controlled, you must do so before making any lot-controlled transactions.

 

WILLIAMS                        INVENTORY CONTROL                      2/15/93

 DSP01                       APPLICATION SYSTEM CONTROL                  DETAIL

                                                                                

                                                                               

                                                                               

                                                                               

    Lot Control Option                              Y                          

    Potency Control Opt                             Y                                              

    Cycle Count Option                              Y                          

    Beginning Month/Year                            1091                       

    Cycle Count Pos Adj Control Code                01                         

    Cycle Count Neg Adj Control Code                02                         

    IC Print Option                                 Y                          

    Customer Order Shipment Code                    SR                         

                                                                                

                                                                               

                                                                               

                                                                               

                                                                               

                                                                               

                                                                               

 F2=Command          F3=Exit             F4=Prompt                             

                                                                               

 

   System-wide Lot Control is Defined on the Application System Control screen (IC160S01).